Pedal Installation; Reflector Installations - Huffy Cruiser Owner's Manual

Pedal Installation

CAUTION: There is a RIGHT pedal marked
and a LEFT pedal marked
NOTE: A Pedal Wrench is preferred for attaching Ped-
als. A thin open-end
wrench can also be used.
• The pedal marked
Tighten it in a clockwise direction.
• The pedal marked
Tighten it in a counterclockwise direction (anti-
clockwise).
• Turn the right pedal marked
of the crank arm, and the left pedal marked
the left side of the crank arm.
Tighten the pedals:
• Make sure the threads of each pedal are fully into
the crank arm.
WARNING
crank arms so they will not loosen. Periodically check
tightness.
Refl ector Installation (as equipped)
Refl ector Installation:
1. Position FRONT Refl ector
straight forward.
2. Tighten Clamp Screw.
3. Position Seat Post Refl ector (if equipped)
B
so it points straight backwards.
4. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will damage
the Clamp.
18
L .
R has right-hand threads.
has left-hand threads.
L
into the right side
R
: Ensure pedals are secure in
A so it points
R
L into
R
B
L
A