Pedal Installation - Huffy Cruiser Bicycles Owner's Manual

Pedal Installation

CAUTION: There is a right pedal marked "R" and a left pedal marked "L".
• The pedal marked "R" has right-hand threads. Tighten it in a clockwise
direction.
• The pedal marked "L" has left-hand threads. Tighten it in a counterclock-
wise direction (anti-clockwise).
• Turn the right pedal marked "R" into the right side of the crank arm, and the
left pedal marked "L" into the left side of the crank arm.
Tighten the pedals (fi g 14):
• Make sure the threads of each pedal are fully into the crank arm.
NOTE: The recommended torque (tightness) for each pedal is 30 ft.-lbs.
Note: A Pedal Wrench is preffered for attaching Pedals. An open-end
18
R
wrench can also be used as shown.
L
fig 14