Ricoh Ri 100 User Manual page 34

Error Messages and Troubleshooting
Error Messages
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
3
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
Adjust height, press Start
to / restart or Tray to reset
garment
34
Troubleshooting
Wrinkles, slack or a float remain on the fabric or
the edges of the fabric are out of the cassette. De-
tach the cassette, and then load the fabric again.
If the message reappears, adjust the height of the
cassette manually.
Thin fabric (up to 16 mm (about 0.6 inches) thick)
is loaded on the bottom row of the multi tray. Load
thin fabric (up to 16 mm (about 0.6 inches) thick)
on the top row of the multi tray.
Thick fabric (16 to 32 mm (about 0.6 to 1.3 inches)
thick) is loaded on the top row of the multi tray.
Load thick fabric (16 to 32 mm (about 0.6 to 1.3
inches) thick) on the bottom row of the multi tray.
Fabric that is 4 mm (about 0.2 inches) or thicker
is loaded on the top row of the sleeve attachment.
Load fabric that is 4 mm (about 0.2 inches) or
thicker on the bottom row of the sleeve attachment.
Fabric that is 20 mm (about 0.8 inches) or thicker is
loaded on the bottom row of the sleeve attachment.
Load fabric that is up to 20 mm (about 0.8 inches)
thick on the top row of the sleeve attachment.
Fabric that is 4 mm (about 0.2 inches) or thicker
is loaded on the A4 standard tray or A5 tray. Load
fabric that is up to 4 mm (about 0.2 inches) thick on
the A4 standard tray or A5 tray.
Fabric that is 32 mm (about 1.3 inches) or thicker is
loaded on the multi tray or the sleeve attachment.
Load fabric that is up to 32 mm (about 1.3 inches)
thick on the multi tray or the sleeve attachment.
Fabric is not set in the center of the multi tray table.
When setting the fabric in the multi tray, set it in the
center of the table.