Table of Contents
Advertisement
15. Digital I/O connector (10-pin DIO1)
This connector includes 8 I/O lines (In/Out programmable). All of the Digital
I/O lines are programmable and each I/O pin can be individually programmed
to support various devices.
EMB-BT1 Digitial I/O connector
16. Serial ATA 3.0Gb/s connectors (7-pin SATA3G_1, SATA3G_2)
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and
optical drives via Serial ATA 3.0 Gb/s signal cables.
EMB-BT1 SATA 3.0Gb/s connectors
NOTES:
•
•
2-22
You must install Windows® XP Service Pack 3 or later version before using
Serial ATA hard disk drives.
When using hot-plug and NCQ, set the SATA Mode Selection item in the
BIOS to [AHCI]. See section 3.3.7 IDE Configuration for details
DIO1
PIN 1
GND
GND
RSATA_RXP2
RSATA_TXP1
RSATA_RXN2
RSATA_TXN1
GND
GND
RSATA_TXN2
RSATA_RXN1
RSATA_TXP2
RSATA_RXP1
GND
GND
EMB-BT1
Advertisement
Table of Contents
