Table of Contents
Advertisement
5.
Serial ATA 6.0Gb/s connectors (7-pin SATA6G_1, SATA6G_2)
These connectors connect to Serial ATA 6.0 Gb/s hard disk drives via Serial
ATA 6.0 Gb/s signal cables.
EMB-BT1 SATA 6.0Gb/s connectors
IMPORTANT:
•
You must install Windows
Serial ATA hard disk drives.
•
When using hot-plug and NCQ, set the SATA Mode Selection item in the
BIOS to [AHCI]. See section 3.3.7 IDE Configuration for details.
6.
SATA power connector (4-pin SATA_PWR1)
This connector is for the SATA power cable. The power cable plug is
designed to fit this connector in only one orientation. Find the proper
orientation and push down firmly until the connector completely fit.
EMB-BT1 SATA POWER Connector
IMPORTANT: The SATA power connector supports 1A current to the
maximum.
Chapter 2: Motherboard information
GND
GND
RSATA_RXP2
RSATA_TXP1
RSATA_RXN2
RSATA_TXN1
GND
GND
RSATA_TXN2
RSATA_RXN1
RSATA_TXP2
RSATA_RXP1
GND
GND
XP Service Pack 3 or later version before using
®
SATA_PWR1
+12V
GND
GND
+5V
2-17
Advertisement
Table of Contents
