Page 3
COM4 control jumper Clear CMOS jumper F_PANEL1 COM5 control jumper Front panel pin header Note. AMB-D255T3 doesn’t design SATA power header on the board. Please use the power supply with SATA power connector for SATA device. - 3 - P/N: 220010447-G...
Page 5
Note. These signals are depend on relevant Jumpers (e.g. Pin1 of J_COM1 depends on J6 Jumper), to find more details, check the following table (Location 8~13 & 27~28). Notes. The pin9 is N/C or 5V or 12V selectable (need corresponding hardware supported), and the default value is N/C.