Honeywell IPC500 Installation Manual page 19

3. Setting up INNER(4)/TIME(4) SIGNAL or INNER(8) SIGNAL
Generally, IPC500's outputs are 4 INNER SIGNALs and 4 TIME SIGNALs.
However, you can use up to 8 INNER SIGNALs
(but 4 TIME SIGNALS cannot be utilized if 8 INNER SIGNALs are used).
— Setting up outputs as 4 INNER SIGNALs and 4 TIME SIGNALs
Push I.S/T.S key (3) shown in Figure 3.2.1. If you choose I.S/T.S, the key is
reversed and SIGNAL output mode indicator (4) is shown as "I.S(4) T.S(4)".
— Setting up output as 8 INNER SIGNALs
Push I.S key (3) shown in Figure 3.2.1. If you choose I.S, the key is reversed
and SIGNAL output mode indicator (4) is shown as "I.S(8)."
Additional Description
Terminal numbers by selecting I.S/T.S Terminal numbers by selecting I.S
INNER SIGNAL 1 → Terminal number : 13
INNER SIGNAL 2 → Terminal number : 14
INNER SIGNAL 3 → Terminal number : 15
INNER SIGNAL 4 → Terminal number : 16
TIME SIGNAL 1 → Terminal number : 17
TIME SIGNAL 2 → Terminal number : 18
TIME SIGNAL 3 → Terminal number : 19
TIME SIGNAL 4 → Terminal number : 20
4. Setting up AUTO TUNING MAN/AUTO
It allows you to set it up so that you can or cannot execute AUTO TUNING in the
operating display.
— To select AUTO TUNING MAN
Push MAN key (5) in Figure 3.2.1. If you choose MAN key, the key is
reversed.
When MAN key is selected, ( TEMP ) AUTO TUNING execution key
does not appear in the monitor screen and you cannot execute AUTO TUNING.
— To select AUTO TUNING AUTO
Push AUTO key (5) in Figure 3.2.1. If you choose AUTO key, the key is reversed.
If AUTO key is set up, ( TEMP ) AUTO TUNING execution key
appears in the monitor screen, which allows you to execute AUTO TUNING.
INNER SIGNAL 1 → Terminal number : 13
INNER SIGNAL 2 → Terminal number : 14
INNER SIGNAL 3 → Terminal number : 15
INNER SIGNAL 4 → Terminal number : 16
INNER SIGNAL 5 → Terminal number : 17
INNER SIGNAL 6 → Terminal number : 18
INNER SIGNAL 7 → Terminal number : 19
INNER SIGNAL 8 → Terminal number : 20
- 14 -