Control Output Specifications - Honeywell IPC500 Installation Manual

Item
POWER FAILURE
Output
SIGNAL
MODE
TIME SIGNAL
TIME MODE
STEP MODE

4.4 control output specifications

Item
PID control
Temperature
ON/OFF control Open collector output(Maximum ON/OFF X 9) - INNER SIGNAL
Proportion (P)
Integral time (I)
Derivative time
PID Constants
Cycle time
Controls right away after recovery of power failure, if the power failure
lasts less than 4 seconds.
For power failure that lasts longer than 4 seconds, setup modes below
will be followed.
BREAK : Stops program
HOT START : Controls at the state just before power
failure
COLD START : It starts again at the beginning of
program
(Note) It is HOT START for fix control
Open collector output X 4
3 kinds of mode setup available (according to numerical inputs of 0-9)
1) ON-OFF mode
2) time mode
3) step mode
: 0 setup OFF (out is OFF at this step)
: 1 setup ON (out is ON at this step)
: Random time signal setup of 2-9 available (8 kinds)
Setup of ON-DELAY time (ON time due to delay)
Setup of CUT-BACK time (beforehand OFF time)
Setup of ON-DELAY time (ON time due to delay)
PID time partition open collector output X 1
PID DC 4~20mA(load resistance 500Ω)X1
0.0~99.99 %
0~36.00 Min
0~36.00 Min
(D)
1~99 seconds
ARW 0~100 %
- 33 -
Specifications
Specifications