Connect Dc Power To The Cisco Asr 1002 Router - Cisco ASR 1002 Quick Start Manual

Figure 11 AC Power Supply for the Cisco ASR 1002 Router
1 2
0
1 Chassis ESD socket
AC power supply slot number 0
2
AC power supply On (I) /Off (O) switch
3
AC power supply LEDs
4
Table 1 describes the AC power supply LEDs on the Cisco ASR 1002 Router.
Table 1 Cisco ASR 1002 Router AC Power Supply LEDs
LED Label LED
INPUT OK Power supply activity
FAN OK Power supply fan activity
A bi-color LED indicates
fan status.
OUTPUT FAIL Power supply activity
Note To connect an AC power supply to the Cisco ASR 1002 Router, follow the steps in
page 31.

Connect DC Power to the Cisco ASR 1002 Router

The DC power supply input connector is a euro-style terminal block. A means to provide strain relief to the input wires is
provided on the power supply. The connection order is negative (–), positive (+), and GND.
3 4 5
OUTPUT INPUT FAN
FAIL OK OK
This unit might have more than
one power supply connection.
All connections must be removed
to de-energize the unit.
8
Color
Green
None
Flashing
Green
Red
Red
6
OUTPUT INPUT FAN
FAIL OK OK
This unit might have more than
one power supply connection.
All connections must be removed
to de-energize the unit.
5 AC power supply fan
AC power supply captive installation screw
6
AC power supply slot number 1
7
AC power inlet
8
Description
The AC power supply input voltage is greater than 85V.
The AC input voltage is less than 70V or the power
supply is turned off.
For an AC input voltage between 70V and 85V the
INPUT OK LED can be either on, off, or flashing
When all fans are operational.
When a fan failure is detected.
LED is off to signal that the DC output voltages are
within the normal operating range. Output voltage
between the minimum and maximum limits will not
create an output fail alarm and output voltages below
the minimum or above the maximum will create an
output fail alarm.
1
7
Installing the AC Power Supply,
15