Cisco ASR 1013 Quick Start Manual page 34

Figure 15 Installing and Removing a SPA Into and From a SIP
After the SPA is properly seated, fasten the SPA in place with the captive installation screws on either side of the SPA.
Step 4
The shared port adapter ships installed. These instructions are provided for future use. Cabling information is included
Note
with the specific shared port adapter documentation.
Attach an ESD wrist strap between you and an unpainted chassis surface.
Step 1
Step 2 If attached, remove any cables from the SPA.
Step 3 Before removing any shared port adapter, shut down the interface so that there is no traffic running through the shared
port adapter when it is removed.
Removing a shared port adapter while traffic is flowing through the ports can cause system disruption.
Note
Remove the shared port adapter from the chassis slot. Unfasten the captive installation screws on either side of the SPA.
Step 4
Step 5 Grasp the handle and pull the shared port adapter or blank shared port adapter from the router.
Step 6 Locate the shared port adapter slot guides inside the Cisco ASR 1013 Router. They are near the top, and are recessed
about one-half inch.
The shared port adapter must slide into the slot guides under the chassis lid. Do not allow the shared port adapter
Caution
components to come in contact with the system board or the shared port adapter could be damaged.
Step 7 Carefully slide the shared port adapter into the shared port adapter slot and seat it. When installed, the shared port
adapter input/output panel should be flush with the face of the router.
34
AS R1 00 0-S
IP1 0
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
PW R STA TUS
AS R1 00 0-S
IP1 0
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
PW R STA TUS
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS
SPA -4X OC
3-P OS