Advertisement
Operating Instructions
ƒ
For drilling, observe the operating instructions of your drill.
ƒ
The magnet holding force of the drill stand mainly depends on the
thickness of the workpiece. The thickness of the material should
not be less than 8 mm.
ƒ
When drilling overhead or on surfaces that are not horizontal,
stand secure the drill satnd with a safety chain. In case of a power
failure or excessive load, the holding force of the magnet is not
maintained. The drill stand can fall down and cause accidents.
ƒ
The surface must be smooth and clean. Smoot out coarse
irregularities, e.g., welding spatter and remove loose rust, dirt and
grease. The holding force of the magnet applies only for appropriate
surfaces.
ƒ
Centre-punch metal workpieces.
Care and Maintenance
Before the beginning of the maintenance or repair works you
have to disconnect the plug from the mains!
Keep the drill stand clean at all times for good working results and safe
working.
If the drill stand should fail despite the care taken in manufacturing and
testing procedures, repair should be carried out by an authorised after-sales
service centre for EIBENSTOCK - power tools.
17
Advertisement
