Advertisement
Assembly – Inserting of the drill in the drill rig
Remove the auxiliary handle from your drill, if required (see the operating
instructions of the drill).
Loosen screw 5 using an Allen key. Insert the drill with the drill collar
5
from above into the drill fixture 4 to the stop. Mount screw 2 in order to
connect the drill with the side holder 3 . Hand-tight screw 5 using an
Allen key.
Check the tight seating of the drill in the drill fixture.
Starting Operation
Switching On and Off
Insert the mains plug of the drill only into socket outlet 7 . Switch the drill on
and lock the On/Off switch of the drill with the lock-on button.
Otherwise, the drill cannot be switched on or off via the On/Off switch
MOTOR 6 on the drill stand.
6
Push the On/Off switch MAGNET 8 upward and check if the drill stand
adheres to the workpiece surface.
To start the drill, press the On/Off switch MOTOR 6 to position "I".
Note: The drill can only be started when the magnet has already been
switched on.
To switch off the drill, press the On/Off switch MOTOR 6 to position "0".
Wait until the drill has come to a complete stop before pushing the On/Off
switch MAGNET 8 downward in order to switch the magnet off.
Restarting protection
The restarting protection prevents uncontrolled starting of the drill after the
power supply is interrupted.
For restarting the operation, press the On/Off switch MOTOR 6
position "I".
Note: The magnet automatically switches on after resumption of the power
supply.
4
8
3
8
6
16
2
5
7
6
6
to
Advertisement
