User Interface Identification - Speck pumps BADU ECOM2/S90 Installation, Operating And Service Manual

M017837080000 REV. January 19, 2011
user Interface Identi cation
This section describes the motor's user interface.
Low High
1 : AM
MTuWThFSaSu
3
Press Enter to Con rm
www.nidec-motor.com/Pool
HIGH SPEED
o ErrIDE
4
run/SToP button. This button is used to activate or stop the unit operation. The button
1
will be not be lit when power is applied to the user interface while in STOP mode and
will be illuminated if in the run mode.
power to the unit.
Press the EnTEr button to confirm and save your selections. Use the   arrow keys
2
for menu navigation purposes and the
changing the time,   keys will move you from the hours to the minute's field, while
the keys will change the hour from 10 to 11 etc.
High Speed override – Runs the motor on high speed and sets countdown timer for
3
60 minutes and will begin counting down. Pressing the button again will end override.
Low Speed override – Runs the motor on low speed and sets countdown timer for
4
60 minutes and will begin counting down. Pressing the button again will end override.
Program
MEnu
Set Clock
Set on Time
Set off Time
override
LoW SPEED
o ErrIDE
NOTICE This button does noT disconnect
!
keys for changing values. For example, while
run / SToP
EnTEr
2EZ Speed Pool Motor with Programmable Control/Timer
TM
1
2
7