Table of Contents
Advertisement
Preparing the Rack and Data Manager
007-4988-001
Figure 1-15
Reversing the Rail Pin Adapter
The following procedures and figures explain how to install the data manager support rails into an
industry-standard rack:
1.
Make sure that the rack is in the final (operating) location and that it meets the following
clearance requirements:
–
76-cm (30 in) clearance in front of the cabinet
–
61-cm (24 in) clearance behind the cabinet
2. Lower the stabilization feet on the rack so it does not move. Use any anti-tip extensions or
other stabilization hardware available with the rack.
Rack Mounting Instructions
17
Advertisement
Table of Contents
Need help?
Do you have a question about the InfiniteStorage NEXIS 2000 and is the answer not in the manual?
Questions and answers