U-Bar Support - Huawei BTS3606 Installation Manual

Installation Manual – BTS3606 Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
Note:
The antistatic floor height refers to the distance between the upper surface of the
antistatic floor and the cement floor.
The heights of A600 series support assemblies I, II, and III can be adjusted steplessly
within their adjustable ranges. You can adjust the heights by moving the upper and
lower supports.
Type IV assembly is a height-fixed support. It is suitable for ultra-high or ultra-low
antistatic floors. But the floor cannot be lower than 140 mm (5.5 in.).
III. Installation Method
Install the support in the floor-bracketing mode. That is, bracket the floor between the
cabinet and the support, and then run the bolts through the antistatic floor to fix the
cabinet and the support. In this way, the cabinet can be firmly fixed and supported.
IV. Quantity
Two supports are needed for each cabinet.

2.2 U-bar Support

I. Outline
The U-bar support is a big base made on the site. The recommended material for the
support is the 14b-3000 type of GB707-88 hot-rolled U-bar.
Figure 2-4 shows the outline of the U-bar support.
Huawei Technologies Proprietary
2-4
Chapter 2 Installing Cabinet Assemblies