Table of Contents
Advertisement
Installation Manual – BTS3606 Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
1.3.4 Power Supply Conditions of the Equipment Room
For more details about the power supply requirements for the equipment room, see
Airbridge BTS3606&3606A CDMA Base Station Installation Manual – Installation
Reference.
1.3.5 Grounding Conditions
Satisfactory grounding is the basic requirement for the stable operation of the
equipment, and is the primary precaution of the access network against thunder
strokes or interference. Carefully check the grounding condition of the installation site
and ensure satisfactory grounding according to actual requirements.
1.3.6 Auxiliary Equipment
The auxiliary devices in this section refer to those that must be ready to use before BTS
installation, including:
Sealing window of feeders
Indoor grounding bar
Cabling rack
Transmission cables or devices for the peer end
Specifically, check the auxiliary devices as follows:
The sealing window, indoor grounding bar, or cabling rack is installed.
Enough cabling holes are available on the sealing window.
The grounding bar can meet the grounding requirements of the BTS, or enough
grounding terminals are available.
The cabling rack can meet the wiring requirements for the BTS.
The transmission devices at the peer end are commissioned and ready for use.
The transmission cables at the peer end are laid down and ready for use.
If there are devices that cannot meet the requirements, it is advised for the customer to
make improvements or reinstall the devices meeting the specified requirements.
1.4 Unpacking
This section describes the requirements and procedures of unpacking wooden cases
and cartons.
1.4.1 Unpacking Requirements
After the project begins, the project supervisor must check the products together with
the customer.
Check the following points:
Huawei Technologies Proprietary
1-4
Chapter 1 Installation Preparations
Advertisement
Table of Contents
