Functional Command Groups; Mmemory; Output; Table 3- 1: :Mmemory Commands - Tektronix AWVG1 User Manual

Functional Command Groups

MMemory

Table 3- 1: :MMEMory commands

Command
:MMEMory:LOAD:SIGNal
:MMEMory:SIGNal:ACTive?

Output

Table 3- 2: :OUTPut commands

Command
:OUTPut:STATe(?)
:OUTPut:SOURce(?)
AWVG1 Wideband Video Generator User Manual
This section describes the module's commands in the following groups:
H MMEMory (see TG 2000 Signal Generation Platform User Manual)
H OUTPut
H SENSe
H SOURce
Entries followed by questions marks are queries; those without question marks
are commands. Entries followed by a question mark in parentheses (?) can be
both a command and a query.
Two MMEMory commands are listed here for your reference. You can use these
to set and query the output test signal for the module. Detailed information for
using these commands (as well as other commands that can be used with the
entire platform) are located in the TG 2000 Signal Generation Platform User
Manual.
Use these commands to select the output characteristics of the module.
Description
Load a signal into a module and identify that signal as the active
signal (output signal) for that module
List the active signal (output signal) for a module
Description
Set or query module output (enabled or disabled)
Set or query the source of the AWVG1 output signal (internal or
external)
3- 5