Removing The Serveraid 8K-L Adapter - IBM x3400 7975 Problem Determination And Service Manual

Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
To install the battery, complete the following steps.
1. Follow any special handling and installation instructions that come with the
2. Insert the new battery:
3. Install the side cover (see "Installing the side cover" on page 101).
4. Lock the side cover if it was unlocked during removal.
5. Reconnect the external cables and power cords; then, turn on the attached
6. Start the Configuration/Setup Utility program and reset the configuration.

Removing the ServeRAID 8k-l adapter

To remove the ServeRAID 8k-l adapter, complete the following steps:
1. Read the safety information beginning on page "Safety" on page vii, and
2. Turn off the server and peripheral devices, and disconnect the power cords and
134
System x3400 Types 7973, 7974, 7975, and 7976: Problem Determination and Service Guide
replacement battery.
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
that the battery clip holds the battery securely.
devices and turn on the server.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See "Using the Configuration/Setup Utility program" on page 166 for details.
"Installation guidelines" on page 95.
all external cables. Remove the side cover (see "Removing the side cover" on
page 100).
Attention: To avoid breaking the retaining clips or damaging the ServeRAID
8k-l adapter connector, open and close the clips gently.