Installing The Hot-Swap Power Supply Docking Cable Assembly - IBM x3400 7975 Problem Determination And Service Manual

5. Lift up the power-supply cage handle and pull the power-supply cage assembly
6. Disconnect the power supply docking cable assembly from the system board.
7. Using a phillips screwdriver, remove the three screws that secure the docking
8. If you are instructed to return the power supply, follow all packaging instructions,

Installing the hot-swap power supply docking cable assembly

To install a new hot-swap power supply docking cable assembly, complete the
following steps:
1. Position the hot-swap power supply docking cable assembly from the inside the
2. Secure the hot-swap power supply docking cable assembly to the chassis with
3. Connect the hot-swap power supply docking cable to the system board.
4. Rotate the power supply cage back into the server.
5. Install the power supplies back into the power supply cage.
6. Install the side cover (see "Installing the side cover" on page 101).
7. Lock the side cover.
8. Reconnect the external cables and power cords; then, turn on the attached
154
System x3400 Types 7973, 7974, 7975, and 7976: Problem Determination and Service Guide
all the way up until the retainer latch locks the cage in place on the chassis.
cable to the chassis; then, remove it from the chassis.
Power supply
docking cable
assembly screws
Power supply
docking cable
assembly
and use any packaging materials for shipping that are supplied to you.
server and insert it in the power supply docking cable slot on the rear of the
chassis (aligning the holes with the screw holes on the chassis).
the three screws that you removed earlier.
devices and turn on the server.