Factory Configuration - NetModule NB3711 User Manual

Parameter
Status
Time of day
URL
Factory Configuration
This menu can be used to reset the device to factory defaults. Your current configuration
will be lost. This procedure can also be initiated by pressing and holding the Reset
button for at least five seconds. A successfully initiated factory reset can be noticed by
all LEDs having been turned on. The factory reset will set the IP address of the first
Ethernet interface back to 192.168.1.1. You will be able to communicate again with
the device using the default network parameters. You may store the currently running
configuration as factory defaults which will reside active even when a factory reset has
been initiated (e.g. by your service staff).
Please ensure that this corresponds to a working configuration. A real factory reset to
NB3711 User Manual 4.0
Automatic File Configuration
Enable/disable an automatic configuration update
Time of day when the system should check for updates
The URL where the configuration file should be retrieved
from (supported protocols are HTTP, HTTPS, TFTP, FTP)
Figure 5.58.: Factory Configuration
163