Equipment Safety - Simoco SDB680 Installation Manual

SDB680 – INSTALLATION GUIDE
H E
UMAN XPOSURE TO
TO COMPLY WITH THE MAXIMUM PERMISSIBLE EXPOSURE (MPE)
LIMITS REFERENCED IN 47 CFR 1.1310 TABLE 1, THE FOLLOWING
MINIMUM SAFE OPERATING DISTANCES MUST BE OBSERVED:
FCC PART 15 C
OMPLIANCE
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
D V
ANGEROUS OLTAGES
Dangerous voltages exist in this equipment, for the appropriate Safety precautions, refer to the relevant
Electrical Safety Regulations appropriate to the country of operation.

EQUIPMENT SAFETY

I
NSTALLATION AND
The SDB680 Series of base stations should only be installed and maintained by qualified personnel.
C
AUTIONS
EQUIPMENT DAMAGE. When the SDB680 Base Station is installed into a rack, DO
NOT use the front panel attachment points to support the full weight of the equipment
or damage to the equipment may result. Suitable shelves or supports MUST be
provided to support the body of the base station along the length of each side.
May 15
R F
ADIO REQUENCY
150 to 174 MHz: 1.8 m
406.1 to 480 MHz: 1.52 m
480 to 512 MHz: 1.49 m
M
AINTENANCE
Before drilling any walls, first check for any buried cables or pipes.
R (FCC)
ADIATION
WARNING
CAUTION
CAUTION
Page 7
TNM-I-E-0046
WARNINGS