Simoco SDB680 Installation Manual page 40

SDB680 – INSTALLATION GUIDE
5.4.5 Enable New Tier III Base
24. On system I/O page, in the System Monitor area, carry out the following:
24.1. On the navigation tree, right click on the new Tier III Base that you wish to enable. Menu
options will be displayed.
24.2. From the menu options, select 'Base Operations' > 'Enable Base(s)'. The base enable
warning message will be displayed.
25.
On the base enable warning message, select 'Yes' to continue.
26. On system I/O page, carry out the following:
26.1. In the System Monitor area, on the navigation tree, confirm that the status notification that was
alongside the relevant base has now disappeared.
26.2. In the Comms History area, after a short delay, confirm that the 'Completed Enabling Base'
message is displayed.
May 15 Page 40
CONFIGURATION TIER II – TIER III
TNM-I-E-0046