Legal Notices & Regulatory Information - Elcometer 407L User Manual

12 LEGAL NOTICES & REGULATORY INFORMATION
The Elcometer 407L meets the Radio and Telecommunications Terminal Equipment Directive. This product is Class B, Group 1 ISM
equipment according to CISPR 11. Class B product: Suitable for use in domestic establishments and in establishments directly
connected to a low voltage power supply network which supplies buildings used for domestic purposes. Group 1 ISM product: A product
in which there is intentionally generated and/or used conductively coupled radio-frequency energy which is necessary for the internal
functioning of the equipment itself.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by Elcometer Limited could void the user's authority to operate the equipment under FCC rules.
is a registered trademark of Elcometer Limited, Edge Lane, Manchester, M43 6BU. United Kingdom.
R
are trademarks owned by Bluetooth SIG Inc and licensed to Elcometer Limited. Bluetooth SIG QDID = B014393.
All other trademarks acknowledged.
www.elcometer.com
13