Table of Contents
Advertisement
10 TECHNICAL SPECIFICATION (continued)
10.2 ELCOMETER 3000 MOTORISED CLEMEN UNIT (continued)
Pollution Degree
Enclosure IP Rating
Dimensions
Weight
Note: For indoor use only at altitudes up to 2000m (6562ft).
Mains supply fluctuations up to 10% of the nominal voltage.
Temporary overvoltages occurring on the supply.
Can be used in accordance with:
AS/NZS 1580.403.1, BS 3900-E2, DIN 53799, ECCA T12, EN 13523-12, ISO 1518-1:2011,
JIS K 5600-5-5
11 LEGAL NOTICES & REGULATORY INFORMATION
Declaration of Conformity:
The Elcometer 3000 Motorised Clemen Unit complies with the requirements of the following EU Directives:
2006/42/EC
Machinery Directive, as amended by 2009/127/EC and 2014/33/EU
2014/30/EU
Electromagnetic Compatibility
The Declaration of Conformity is available to download via:
www.elcometer.com/images/stories/PDFs/Datasheets/Declaration_of_Conformity/English/DoC_3000_Motorised.pdf
This product is Class B, Group 1 ISM equipment according to CISPR 11.
Class B product: Suitable for use in domestic establishments and in establishments directly connected to a low voltage
power supply network which supplies buildings used for domestic purposes.
Group 1 ISM product: A product in which there is intentionally generated and/or used conductively coupled radio
frequency energy which is necessary for the internal functioning of the equipment itself.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
-- Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a separation distance of
20 cm or more should be maintained between the antenna of this device and persons during operation. To ensure
compliance, operation at closer than this distance is not recommended. The antenna(s) used for this transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.
Modifications not expressly approved by Elcometer Limited could void the user's authority to operate the equipment
under FCC rules.
is a registered trademark of Elcometer Limited, Edge Lane, Manchester,
R
M43 6BU. United Kingdom
All other trademarks acknowledged.
The Elcometer 3000 Clemen Unit is packed in a plywood and / or heavy duty cardboard and foam package. It is
recommended that this packaging is retained and reused in the event that the instrument needs to be transported. If
the packaging is disposed of, please ensure that this is done in an environmentally sensitive manner. Consult your
local Environmental Authority for further guidance.
Head-Office: Elcometer Limited, Edge Lane, Manchester, M43 6BU, United Kingdom.
R
2
IP20
460 x 280 x 330mm (18 x 11 x 13")
20kg (44lb)
TMA-0326 Issue 04 - Text with cover 19438
Advertisement
Table of Contents
