Error Messages - Microlife WatchBP Office BASIC+ Instruction Manual

Error messages

If an error occurs during measurement, the
measurement is interrupted and an error message
«Err» is displayed.
•
Please contact your local
Microlife service center if the
error persists.
•
If you think the results are
unusual, please read through
the information in this
instruction manual carefully.
19
Error Description
«Err 1» Signal too
weak
«Err 2» Error signal
Potential cause and
remedy
The pulse signals on
the cuff are too weak.
Re-position the cuff and
repeat the measurement.
During the measurement,
error signals were
detected by the cuff,
caused for instance by
movement or muscle
tension. Repeat the
measurement, keeping
your arm still.