If The 3D Image Cannot Be Viewed; Preparing The 3D Glasses; Charging The 3D Glasses - Epson EH-LS10500 User Manual

Basic Operations

If the 3D image cannot be viewed

Check the following if the 3D effect is not applied correctly, even after setting the 3D formats.
• The synchronization timing for the 3D Glasses may have been inversed. Inverse the synchronization using Inverse
3D Glasses, and then try again. s Signal - 3D Setup - Inverse 3D Glasses
• The image is not displayed in 3D if 3D Display is set to Off. Press the
3D Setup - 3D Display
c
•
How a 3D image is perceived varies depending on the individual.
•
When a 3D image is displayed, a warning about viewing 3D images is displayed. You can turn off this
warning by setting 3D Viewing Notice to Off.
•
You can also convert 2D images to 3D images.
•
During 3D image projection, the following Configuration menu functions cannot be changed.
Aspect (set to Normal
Picture in Picture
*
You can select Anamorphic Wide only when 1080p/24 Hz/frame packing signals are projected.
•
How the 3D image is viewed may change depending on the temperature of the surroundings. Refrain
from using the projector if the image is not projected normally.

Preparing the 3D Glasses

Use 3D Glasses to view 3D images.
c
The 3D Glasses come with protective stickers. Remove the protective stickers before use.

Charging the 3D Glasses

Charge using the optional USB Charging Adapter.
Charging using the USB Charging Adapter
Use the USB cable to connect the 3D Glasses to the USB Charging Adapter, and then connect the USB Charging
Adapter to an electrical outlet.
p.70
*
), Noise Reduction (set to Off), Overscan (set to Off), Advanced - Sharpness,
p.70
button on the remote control. s Signal -
Signal - 3D Setup - 3D Viewing Notice
s
p.40
s
38
p.70