Table of Contents
Advertisement
Troubleshooting
Images appear dark
Check
Is the image brightness set correctly?
Is the contrast adjusted correctly?
Images are rough (when connected to the HDMI1 port)
Check
Has EDID been set?
Projection stops automatically
Check
Is Sleep Mode enabled?
The Panel Alignment adjustment is not satisfactory or difficult to achieve
Check
Does the Projection setting match the pro-
jector's installation position?
Is the projection surface suitable?
Were adjustments made immediately after
the projector was turned on?
Is the image size suitable?
Is the shifted color magenta?
Do the lines in the pattern look fuzzy or out of
focus?
Adjust the Brightness setting from the Configuration menu.
Image - Brightness
s
Adjust the Contrast setting from the Configuration menu.
Image - Contrast
p.68
s
Remove the HDMI cable, and then make EDID settings.
If the set time is exceeded and no signal is input, the laser turns
off automatically, and the projector enters standby status. The
projector returns from standby status when you press the
button on the remote control or the
panel. Do not look into the laser when returning from standby
status. If you do not want to use Sleep Mode, change the setting
to Off.
Settings - Operation - Sleep Mode
s
The panel alignment adjustment method changes depending
on the Projection setting. Make sure the Projection setting
matches the projector's installation position.
jection
p.73
For best results, the projection surface should not be colored or
textured, otherwise the adjustment grids will be difficult to align.
Project onto a screen and so on that is white and does not have
a pattern.
To obtain stable image quality, leave the projector on for a while
before making adjustments.
The projected image should be a minimum of 60".
Adjust R (red) and B (blue) for Select Color since magenta is a
mixture of red and blue.
Adjust the focus.
p.30
s
90
Remedy
p.68
Remedy
Remedy
button on the control
p.73
Remedy
Settings - Pro-
s
Advertisement
Table of Contents
