Table of Contents
Advertisement
Troubleshooting
Check
Has the power to the AV amplifier been dis-
connected?
Is an image signal being sent from the device? Check that an image signal is being sent from the connected
Is the image signal format setting correct?
Are the Configuration menu settings correct? Reset all of the settings.
(Only when projecting computer image sig-
nals)
Was the connection made while the power of
the projector or the computer was already
turned on?
Moving images are not displayed
Check
(Only when projecting computer image sig-
nals)
Is the computer's image signal set to external
output and to output to the LCD monitor at
the same time?
"Not supported" is displayed
Check
Is the image signal format setting correct?
(Only when projecting computer image sig-
nals)
Do the image signal's frequency and resolu-
tion correspond to the mode?
If an AV amplifier is connected, check the AV amplifier's power
supply.
device.
When Video is input
If nothing is projected even when Video Signal is set to Auto
from the Configuration menu, set the signal that matches the
connected device.
Settings - Input Signal - Video Sig-
s
nal
p.73
When Component is input
If nothing is projected even when Component is set to Auto
from the Configuration menu, set the signal that matches the
connected device.
Settings - Input Signal - Compo-
s
nent
p.73
If the connection is made while the power is already turned on,
the key (Function key and so on) that changes the computer's
image signal to external output may not work. Turn off the con-
nected computer, and then turn it back on.
Depending on the computer's specifications, moving images
may not be displayed when the computer is set to external out-
put and to the LCD monitor output at the same time.
Change it so that the image signal is set to external output only.
For the computer's specifications, see the documentation sup-
plied with the computer.
When Video is input
If nothing is projected even when Video Signal is set to Auto
from the Configuration menu, set the signal that matches the
connected device.
Settings - Input Signal - Video Sig-
s
nal
p.73
When Component is input
If nothing is projected even when Component is set to Auto
from the Configuration menu, set the signal that matches the
connected device.
Settings - Input Signal - Compo-
s
nent
p.73
Check the image signal being input in Resolution from the Con-
figuration menu, and check that it corresponds to the projector's
resolution.
p.98
s
87
Remedy
Reset - Reset All
p.82
s
Remedy
Remedy
Advertisement
Table of Contents
