Epson EH-LS10500 User Manual page 34

Basic Operations
a
Press the
c
You can make settings from the
Configuration menu.
Aspect p.70
By normally selecting Auto, the optimum aspect is used to display the input signal. Change the setting if you
want to use a different aspect.
The table below shows the image projected on a 16:9 screen.
Input Image
4:3 images
16:9 images
Images recorded using
squeeze
*
Letterbox images
Notes
*
The letterbox image used in this explanation is a 4:3 aspect ratio image displayed in 16:9 with black margins at
the top and bottom for subtitle placement. The margins at the top and bottom of the screen image are used for
subtitles.
With this projector you can also set Anamorphic Wide and Horiz. Squeeze.
Set Anamorphic Wide and attach a commercially available anamorphic lens to enjoy DVDs, Blu-rays, and so
on of images recorded at Cinema Scope size.
button.
Signal -
s
Normal
Matches the vertical size
of the projection panel.
The aspect ratio differs
depending on the input
image.
b
Use the
select the setting name, and then
press the
selection.
c
Aspect may not be available
depending on the type of signal.
Setting Name (Aspect)
Full
When projecting 16:9 images, Full and Zoom cannot
be selected.
Uses the entire projection
panel.
33
buttons to
button to confirm the
Zoom
Retains the aspect ratio of
the input signal, and
matches the horizontal
size of the projection pan-
el. The top and bottom of
the image may be trunca-
ted.