Installing; Notes On Installing - Epson EH-LS10500 User Manual

Preparing

Installing

Notes on Installing

Warning
Ceiling mount installations
•
A special method of installation is required when suspending the projector from a ceiling (ceiling mount). If
it is not installed correctly, it could fall causing an accident and injury.
•
If you use adhesives, lubricants, or oil on the ceiling mount fixing points to prevent screws from loosening,
or if you use things such as lubricants or oils on the projector, the projector case may crack causing it to fall
from its ceiling mount. This could cause serious injury to anyone under the projector and also damage the
projector.
•
Do not setup the projector on its side. This may cause malfunctions to occur.
•
Try not to setup the projector in locations subject to high humidity and dust, or in locations subject to smoke
from fires or tobacco smoke.
Warning
About laser products
(Europe and Japan)
•
This product is a class 1 laser product that conforms to IEC60825-1:2014 and JIS C 6802:2014.
(Other areas)
•
This product is a class 2 laser product that conforms to IEC60825-1:2007 and GB7247-1:2012.
•
Do not look into the lens during projection.
•
Do not allow small children to make operations. If children do make operations, they must be accompanied
by an adult.
Caution
•
When lifting the projector, be careful not to drop it as it is heavy and could cause an injury.
•
When installing the projector on a shelf and so on, take additional measures to prevent it from falling, such
as securing with a wire. If it falls it could cause an injury.
15