Installer Manual; Electrical Connections - Gemini 7590TK15 Installation And Use Manual

!
Implement the electrical engine blocks by working on the fuel pump and the
starter motor.
!
Connect the alarm positive supply to the vehicle battery or to one of its
derivations.
!
Connect the alarm negative supply to the vehicle chassis ( 2 BLACK wires
marked M).
!
ALWAYS connect 1 of the alarm GREEN/BROWN wires to the door switch.
!
Connect (if necessary) the other alarm GREEN/BROWN wire to the door
switch.
!
ALWAYS connect the alarm GREEN wire to the bonnet switch.
!
Before programming the system,
!
For CDL connections refer to wiring diagram.
NB: available diagrams, for each specific vehicle, can be requested to
the zone dealer.
The table below refers to the alarm wiring diagram (see opposite page).
Before carrying out electrical connections, disconnect the NEGATIVE
! !
BATTERY TERMINAL and only reconnect after completion.
Engine immobilization 1
Engine immobilization 1
Door pin switches
Bonnet/boot switches
Positive alarm ON
External sensor input
Negative control for additional siren
Self-powered siren
Turn indicators
Negative output for electric boot release
CDL (see diagram)
NB: The BLACK 2-pin connectors in the alarm harness are for the
electronic key and LED connections.
PAGE 8

INSTALLER MANUAL

5.0 - ELECTRICAL CONNECTIONS

FUNCTION
Negative
Positive
Ignition
complete all electrical connections
2 BLACK wires marked 'M'
2 BLACK wires marked
2 BLACK wires marked 'B'
2 GREEN/BROWN wires
YELLOW/BLUE RED/BLUE
YELLOW/BROWN RED/BROWN
YELLOW/GREY RED/GREY
WIRE COLOUR
BLACK marked
BLACK marked 'G'
2 GREEN wires
PINK
GREEN/BLACK
YELLOW/BLACK
BLUE
2 ORANGE wires
GREY-BLACK
.
'R'
'H'