Greenlee 881 Cam Track Instruction Manual page 18

Assembly and Operation Instructions
881 and 881CT with 1813 Bending Table (cont'd)
35. Position the vise unit at a distance from the pump
support so that the vise unit will not contact the
pump support before the bend is complete. Clamp
the conduit down in the vise unit.
SADDLE
PIN
36. Push the follow bar back (to the right in the illustra-
tion) until the follow bar foot contacts the bender
mounting unit. Position the saddle and saddle pin
(M) where they can be reached for assembly.
37. Rock the bender frame as shown and rotate the
shoe back for the assembly of the saddle and pin.
Greenlee / A Textron Company
881 and 881CT Cam Track
38. Hold the shoe against the conduit and position the
saddle so the saddle insert is toward the operator.
Align the hole in the saddle with the hole in the shoe
and insert the saddle pin (M). Secure the saddle pin
with the hitch pin clip (E).
SADDLE INSERT
39. Allow the bender to rock forward and ensure that the
follow bar comes forward with it, so that the follow
bar contacts the saddle.
Follow the instructions and safety information
supplied with your hydraulic pump.
40. Rotate the pump control lever counterclockwise.
Activate the hydraulic pump until the shoe just
contacts the conduit. Check that the saddle and
follow bar are snug, and that the follow bar is
against the saddle, as shown. Be sure that the
bending mark on the conduit is aligned with the front
edge of the saddle insert. Attach the model 1805
Bending Degree Indicator (35) to the conduit. Zero
the indicator by rotating the degree wheel.
18
®
Hydraulic Benders
SADDLE
ALIGN BENDING MARK WITH
FRONT EDGE OF SADDLE INSERT
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070