Fujitsu FI-5950 Operator's Manual page 148

Item
Sheet count
For evaluating the consumable replace-
(Consumables ment cycle or cleaning cycle.
counter) Use this function to reset the counters
after replacing consumables or the
cleaning.
Refer to
Replacement Cycle" on page
Power saving Select the waiting time before entering
the Power saving mode.
Refer to
on page
Power off after a certain period of
time: Select to have the scanner turn
off automatically when it is turned on
and left unused for a certain period of
time. Also, specify the time until
power-off.
Refer to
on page
Offset setting
Adjust the start position for the docu-
ment scanning.
Refer to
page
Vertical magnifi-
Adjust the magnification in the feed-
cation Adjustment
ing direction.
Refer to
page
*1: Depending on the "PART NO." on the product label, the factory default setting differs as follows:
PART NO.
PAxxxxx-Bxx1
PAxxxxx-Bxx2 /Bxx3 /Bxx5 /Bxx7
For details about product labels, refer to
Explanation
"5.1 Consumables and
74.
"8.2 Power saving setting"
142.
"8.2 Power saving setting"
142.
"8.3 Offset/Scan scale" on
143.
"8.3 Offset/Scan scale" on
143.
Selected / 4 Hours
Not selected
"6.5 Labels on the Scanner" on page 109
Selectable parameter
After Cleaning/Pad/Pick roller/Sep-
arator Roller/Brake roller/Remaining
ink level (only for the imprinter
option)
Setting range 15 to 55 minutes (set in
steps of 5 min.)
[Power off after a certain period of
time] check box
1 Hour/2 Hours/4 Hours/8 Hours
(when the above check box is
selected)
Left right: setting range -2 to 3mm
(set in 0.5mm steps)
Up down: setting range -2 to 3mm (set
in steps of 0.5mm)
Setting range -6.3% to 6.3% (set in
0.1% steps)
Default
8.1 Scanner Settings
Default
-
15 min.
(*1)
left right
0mm
up down
0mm
0%
.
137
8