Starting Scanning With Button - Fujitsu FI-5950 Operator's Manual

2.11 Starting Scanning with Button

Pressing the [Scan] / [Send to] button can start an application previously linked.
However, you need to set the application for [Scan] and [Send to] button referring to
[Scan] / [Send to] button" on page
1. Load the documents on the hopper.
Refer to the section
2. Adjust the stacker table to the document size.
Refer to "2.7 Setting up the Stacker" on page
3. Press the [Scan] or [Send to] button.
When using the [Scan] button, press the button.
When using the [Send to] button, you can set from [Send to 1 to 9] of nine (9) kinds of settings.
Each pressing the [Function] button increases the number of Function Number display as 1  2
 3.... Set the number that links the application software you want to use for scanning and
press the [Send to] button.
 The application previously set for the number is started.
ATTENTION
32

2.11 Starting Scanning with Button

39.
"2.6 Loading Documents on the Hopper" on page
Function Number display
If the [Send to] button is pressed when "C" is displayed in the Function
Number Display, the Software Operation Panel will start (see
17.
22.
[Function] button
Function
Hopper Height
Paper Thicknes s
Thin Thick
Send to Scan
"2.13 Before Using
page 127).