Printing Using a Computer
• If your P-touch labeling system could not connect to the network, a message indicating that the connection
failed appears.
Configuring by entering the PIN
a
Select [Settings] in the Home screen using the , ,
key.
b
Select [WLAN] using the
c
Select [Infrastructure Mode] using the
d
Select [Network Setting] using the
e
Select [PIN Code] using the
f
If some messages appear, press the OK or Enter key for each message.
g
Type the PIN displayed on the screen into your wireless access point/router, and then press the OK
or Enter key.
h
Connecting... appears for a while, and then Connected! appears.
i
Press the OK or Enter key.
The screen returns to the Settings menu screen.
Depending on the strength of the wireless signal, the wireless connection indicator may show one of
the following symbols:
Note
If you start the setup wizard for the Infrastructure mode or select the network settings for the Direct mode
when the wireless function of the P-touch labeling system is turned off, Turning on Wi-Fi Radio
appears and the wireless function turns on automatically (or after the OK key is pressed). It is no longer
necessary to turn the Infrastructure mode or Direct mode on manually.
or
key, and then press the OK or Enter key.
or
or
key, and then press the OK or Enter key.
or
key, and then press the OK or Enter key.
or
key, and then press the OK or Enter
key, and then press the OK or Enter key.
4
68