Removing The Rechargeable Li-Ion Battery; Charging The Rechargeable Li-Ion Battery - Brother PT-D800W User Manual

Using the Rechargeable Li-ion Battery (Optional: PA-BT-4000LI)

Removing the Rechargeable Li-ion Battery

Press and hold the (Power) Button to turn off the P-touch labeling system.
Remove the battery cover and the battery, and then reattach the battery cover.
CAUTION
If it is difficult to remove the rechargeable battery, turning the P-touch labeling system over with the battery
cover removed may allow the rechargeable battery to fall out.
Be careful that this does not cause any injuries.

Charging the Rechargeable Li-ion Battery

Note
• Before use, fully charge the battery.
• Up to three hours may be needed to fully charge the battery.
a
Make sure the battery is installed in the P-touch labeling system.
b
Use the AC Adapter and Power Supply Cord to connect the P-touch labeling system to an AC Power
Outlet.
Press the (Power) Button to turn on the P-touch labeling system if it is not on already.
The (Battery) Indicator lights in orange during charging, and it goes off when the battery is fully
charged.
1 AC Adapter
2 Power Supply Cord
Note
• Even if the P-touch labeling system is turned off during charging, the charging will continue until the battery
is fully charged.
1
2
24
24
24
185