Setting Up the P-touch Labeling System
Feeding Tape
Important
• Be sure to feed tape to remove any slack in the tape and ink ribbon after inserting the Tape Cassette.
• Do not pull the label when the P-touch labeling system is ejecting it from the Tape Exit Slot. Doing
so will cause the ink ribbon to be discharged with the tape. The tape may no longer be functional after the
ink ribbon discharges.
• Do not block the Tape Exit Slot during printing or when feeding tape. Doing so will cause the tape to jam.
Press the Esc key to exit or cancel either function.
Feed and Cut
The Feed and Cut function feeds approximately 0.88" (22.3 mm) of blank tape, and then cuts the tape.
a
Press the
(Feed and Cut) Button.
[Feed & Cut?] appears on the LCD.
b
Select [Feed & Cut] using the
Tape... Please Wait] appears while the tape is fed, and then the tape is cut.
Feed Only
This function ejects the tape approximately 0.88" (22.3 mm), resulting in a blank label sticking out of the Tape
Cassette. This action is recommended when using Fabric tapes, which should be cut with scissors.
a
Press the
(Feed and Cut) Button.
[Feed & Cut?] appears on the LCD.
b
Select [Feed Only] using the
Tape... Please Wait] appears while the tape is fed.
or
key, and then press the OK or Enter key. The message [Feeding
or
key, and then press the OK or Enter key. The message [Feeding
1
1
1
1
8