Table of Contents
Advertisement
Chapter 4
Installation
The P332GT-ML is ready to work after you complete the installation instructions
below.
Required Tools
Make sure you have the following tools at hand before undertaking the Installation
procedures:
•
Philips (cross-blade) screwdriver
Site Preparation
Avaya P330 can be mounted alone or in a stack in a standard 19-inch equipment
rack in a wiring closet or equipment room. Up to 10 units can be stacked in this way.
When deciding where to position the unit, ensure that:
•
It is accessible and cables can be connected easily and according to the
configuration rule.
•
Cabling is away from sources of electrical noise such as radio transmitters,
broadcast amplifiers, power lines and fluorescent lighting fixtures.
•
Water or moisture cannot enter the case of the unit.
•
There is a free flow of air around the unit and that the vents in the sides of the
case are not blocked.
Note: Use Octaplane cables to interconnect with other switches.
•
The environmental conditions match the requirements listed below:
Table 4.1
Operating Temp.
Relative Humidity
Avaya P332GT-ML User's Guide
Environmental Prerequisites
-5 to 50°C (23 to 122°F)
5% to 95% non-condensing
17
Advertisement
Table of Contents
Troubleshooting
