Avaya P332GT-ML Installation And Configuration Manual page 43

Table 6.1
LED Name
FC
Hspd
LAG
Note: All LEDs are lit during reset.
Table 6.2
Description
Left/Right
Reset module
Reset stack
Avaya P332GT-ML User's Guide
Chapter 6
Avaya P332GT-ML LED Descriptions (Continued)
Description
Flow Control
High Speed
Link Aggregation
Group (Trunking)
Avaya P332GT-ML <- -> Select buttons
Function
Individual – select LED function (see table above)
Press both right and left buttons together for approximately 2
seconds. All LEDs on module light up until buttons are
released.
Press both Right and Left buttons together for 4 seconds. All
LEDs on stack light up until buttons are released.
Avaya P332GT-ML Front and Rear Panels
LED Status
OFF – No flow control.
ON – One of the three possible flow control
modes is enabled.
Note: FC LED for Gigabit Ethernet ports
reflect the last negotiated mode when
autonegotiation is enabled and the link is
down.
Ports 1-10
OFF: 100 Mbps N/A
ON: 1000 Mbps 1000 Mbps
OFF – No LAG defined for this port
ON – Port belongs to a LAG
Ports 51,52
29