Table of Contents
Advertisement
Alcatel-Lucent
The rear panel elements are as follows:
Rear panel connectors table
Item
A
B
C
D
E
F
G
H
I
J
K
L,M
In addition to the connections, you can see a set of luminous indicators, or LEDs, on the rear panel that provide in-
formation on what is happening in the router.
The LEDs on the rear panel of the router are shown in the following figure:
Rear panel LEDs
Fig. 3:
Rear panel LEDs table
LED
A
OA5725A Router
Description
ANT. 1 Wi-Fi. WiFi antenna for the Wireless LAN module. This module is optional;
therefore it's possible that your device doesn't have any antennas.
ANT. 1 CELL 1. Main antenna for the OA5725A cellular Module 1
(cellular10/xinterface).
ANT. 1 CELL 2. Main antenna for the OA5725A cellular Module 2
(cellular11/xinterface).
GPS. External GPS antenna for the GPS module. This module is optional; there-
fore it's possible that your device doesn't have internal GPS and, therefore, no an-
tenna.
ANT. 2 CELL 1. Auxiliary antenna for the OA5725A cellular Module 1
(cellular10/xinterface).
ANT. 2 CELL 2. Auxiliary antenna for the OA5725A cellular Module 2
(cellular11/xinterface).
ANT. 2 Wi-Fi. WiFi antenna for the Wireless LAN module. This module is optional;
therefore it's possible that your device doesn't have any antennas.
4-port Ethernet Switch.
AUX. DB9 connector that provides access to the device's local console for config-
uration and monitoring.
RESET. Reset button. For further information on how the reset button operates,
please see section
RESET Button
12 - 24 V DC Power supply connection (DC).
Screws to remove the device's upper and underside panels.
Associated Interface
Wireless WAN channel 0
on page 15 in this chapter.
Statue
Monochrome
3 Components and Power Supply
Description
OFF -> Interface is not
5
Advertisement
Table of Contents
