PIAGGIO MP3 400 i.e. Service Manual page 127

MP3 400 i.e.
- Lubricate the intermediate gear seat with torque
limiter on the flywheel cover.
- Align the water pump movement sensor with a
reference and install the flywheel cover as descri-
bed in the Flywheel cover chapter.
- Install a new gasket on the engine crankcase.
- Check the presence of the three centring dowels.
- Turn the crankshaft in order to align the counter-
shaft movement sensor with a reference point on
the crankcase (see figure).
- Repeat the alignment for the water pump crank-
shaft using the same reference point on the en-
gine.
N.B.
THIS PREPARATION IS USEFUL PARTICU-
LARLY IN THE EVENT OF REPAIRS WITH THE
WATER PUMP COVER INSTALLED.
- Install the flywheel cover on the engine, paying attention to avoid interference between the stator and
rotor.
WARNING
FAILURE TO OBSERVE THIS INSTRUCTION MAY RESULT IN DESTRUCTION OF THE CERAMIC
MAGNETS.
Engine
ENG - 35