Start To Fly - UBSAN Q4 FPV Instruction Manual

Disassemble the propellers with
U wrench.
● Make sure that the A and B propellers are installed correctly. The X4 will not fly if
propellers are improperly installed.
● Hazardous moving parts keep fingers and other body part away.

6. START TO FLY

6.1 FLIGHT ENVIRONMENT
(1) The flying area should be open and without tall buildings or other obstacles; the steel
structure within buildings interferes with the compass and the GPS signal.
(2) DO NOT fly in bad weather such as strong wind, heavy snow, rain or fog.
(3) Keep away from barriers, people, power cables, trees, and other obstructions.
(4) Do NOT fly near radio towers or airports.
(5) The X4 control system will not work properly at the South or North Pole.
(6) DO NOT fly in restricted areas and obey your country's laws and regulations.
High Tension Line
6.2 BINDING
Power on the transmitter until "Bind to Plane" displayed, then power on the drone, and
place it very close to the transmitter, the binding will be completed after one " beep"
heard.
Should the binding failed, please power off the drone and repeat above steps.
©
08
2015 Hubsan
哈博森科技 版权所有
Airport Interference Rain