Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for UBSAN Q4 FPV
Summary of Contents for UBSAN Q4 FPV
- Page 1 ® PLEASE READ THE INSTRUCTION MANUAL CAREFULLY BEFORE USE Q4 FPV NO: H111D...
-
Page 3: Table Of Contents
INDEX IMPORTANT SAFETY NOTES START TO FLY 7.1Normal mode / Expert Mode SYMBOL EXPLANATION 7.2 Headless mode USAGE ADVICE 7.3 Aerial Flip LIPO BATTERY SAFETY NOTES TRANSMITTER INDEX 8.1 input key function INTRODUCTION 8.2 Install the TX Battery 1 ITEMS INCLUDED IN THE BOX 8.3 Video REPLAY setup 2 QUAD COPTER 8.4 TIME setup... -
Page 4: Important Safety Notes
Please read the instruction manual carefully! IMPORTANT SAFETY NOTES OPERATION: Be extremely careful and responsible when using the drone. Small electronic components can be damaged by crashing or by dropping the X4 into water. To avoid further damages, please replace broken parts immediately. Flight: Take responsiblity for the safety of yourself and others when flying the X4! Do not fly the X4 in crowded places. -
Page 5: Introduction
INTRODUCTION Thank you for buying HUBSAN products. The X4 quadcopter is designed as an easy-to-use, full-featured RC model capable of hovering and acrobatic flight maneuvers. Please read the manual carefully and follow all the instructions. Be sure to keep the manual for future reference. -
Page 6: Quad Copter
2 QUADCOPTER [1] Propellers [2] Charging Plug [3] Motor [4] Camera 3. MOTOR LED INDICATOR Indicator Status: Front LED: is blue; Back LED: is red Power on: 1) Before binding, 2 front LED indicators blink alternately 2) After binding, 4 LED indicators remain lighted Headless Flight: 2 front LED blink slowly, 2 back LED remain lighted Video: 2 front LED remain lighted, 2 back LED blink alternately Low Power: 2 front LED remain lighted, 2 back LED blink quickly... -
Page 7: Charging
4.2 CHARGING Connect the battery to the USB charger, then connect the USB charger to USB devices, such as a computer or mobile power charger. It takes around 30 minutes to fully charge the battery. The USB LED indicator is in red when charging and will light off when the battery is fully charged. -
Page 8: Start To Fly
Disassemble the propellers with U wrench. ● Make sure that the A and B propellers are installed correctly. The X4 will not fly if propellers are improperly installed. ● Hazardous moving parts keep fingers and other body part away. 6. START TO FLY 6.1 FLIGHT ENVIRONMENT (1) The flying area should be open and without tall buildings or other obstacles;... -
Page 9: Basic Flight
6.3 BASIC FLIGHT The operation mode for the transmitter including Mode 1 or Mode 2. The manual will use Mode 2 as an example to illustrate the transmitter’s operation. Transmitter (Model 2) Remarks The throttle stick controls the ascent and descent . -
Page 10: Video
The Aileron stick controls left and right flight. Push the stick to the left and the X4 will fly to the left. Push the stick to the right and the X4 will fly to the right. The X4 will keep the current status when the stick is in the center. -
Page 11: Headless Mode
7.2 HEADLESS MODE Headless mode means the X4 will default any direction (corresponding to the directions of transmitter sticks) as its up head when the mode is activated. MODE 1 MODE 2 Press the Throttle stick 0.5 second to switch on/ off headless mode. Press the stick to enter into the headless Mode, indicated by one "beep"... - Page 12 7.3.2 Right Flip Push the Aileron stick to the right. Release the stick to the center after the flip. MODE 2 MODE 1 7.3.3 Forward Flip Pull the Elevator stick forward. Release the stick to the center after the flip. MODE 2 MODE 1 7.3.4 Backward Flip...
-
Page 13: Transmitter
8. TRANSMITTER Quad copter’s battery capacity Transmitter’s battery capacity Recording time 0:08:49 Video ThrottleTrimming ElevatorTrimming Rudder Trimming Aileron Trimming MODE 1 Quad copter’s battery capacity Recording time Transmitter’s battery capacity 0:08:49 Video ThrottleTrimming ElevatorTrimming Aileron Trimming Rudder Trimming MODE 2 8 Video 4Elevator Trim 6 Throttle Trim... -
Page 14: Input Key Function
8.1 INPUT KEY FUNCTION Mode/ Control Function Push the stick forward or backward and the quadcopter will MODE 1 ascend or decend; Push the stick left or right and the quadcopter Throttle/Aileron Stick will fly left or right. Push the stick forward or backward and the quadcopter will fly MODE 1 forward or backward;Push the stick left or right and the quadcopter Elevator/Rudder Stick... -
Page 15: Install The Tx Battery
8.2 INSTALL THE TX BATTERY PUSH PUSH Install 4 x AA batteries Close the cover Remove the cover according to the correct polarities ● Do not mix old and new batteries ● Do not mix different types of batteries ● Do not charge non-rechargeable battery. Notice：... -
Page 16: Time Setup
0:08:49 0:08:49 MAIN MENU PLAY RECORD Play Record PREV NEXT Set Real Time Stop and Exit Format SD Card 001.avi 00:01 Set Reverse 002.avi 00:00 Set Sensitive 5.8G Frequence Exit 8.4 TIME SETUP Pull the throttle stick to the lowest position and long press the Pitch stick simultaneously to enter into MAIN MENU interface. -
Page 17: Reversing Channel Setup
8.6 REVERSING CHANNEL SETUP If you would like to reverse any of the stick functions due to personal preference then follow the instructions below. Be aware that it will change the controls back to front. Pull the throttle stick to the lowest position and long press the Pitch stick simultaneously to enter into MAIN MENU interface. -
Page 18: Frequency Selectable 5.8Ghz
8.8 FREQUENCY SELECTABLE 5.8GHZ The transmitter will automatically find the best frequency to ensure a live video with good quality of transmission. Please re-select the frequency from 5730MHZ to 5845MHZ to get a better video transmission when necessary. Pull the throttle stick to the lowest position and press the Elevator stick for 1.5 second to enter into the MAIN MENU interface. -
Page 19: Exploded View
EXPLODED VIEW PART NAME PART NAME Propeller A Li-Po Battery Propeller B PCBA Propeller A Motor Holder Propeller B Camera Module Motor A Lower Body Shell Screw Motor B Upper Body Shell © 2015 Hubsan 哈博森科技 版权所有... -
Page 20: H111D Spare Part Chart
H111D SPARE PART CHART H111D-01 H111C-02 H111D-02 H111C-04 Body Shell Set Motor Holders Propeller Set Motor Set H111D-03 H111C-05 H111D-04 H111C-07 Camera module Lipo Battery 2.4G & 5.8G 2 in1 PCBA Screw Set H111C-10 H107D-A05 USB Charger Transmitter © 2015 Hubsan 哈博森科技 版权所有... -
Page 21: Fcc Information
FCC INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.