Pixsys ATR243 User Manual page 40

0-5000 [digit
Default: 10.
59 Operating Mode
op.mo.
Select operating mode. (See paragraphs 7.7 and 7.11)
Controller (Default)
cont.
Pre-programmed cycle (See paragraph 7.7)
pr.cY.
Setpoint change by digital input
2t.s.
Setpoint change by digital input with impulse command
2t.s.i.
3 sets change by digital input with impulse command
3t.s.i.
4 sets change by digital input with impulse command
4t.s.i.
Reset time (custom function)
t.res.
Pre-programmed cycle with Start / Stop only by digital input
p.c.s.s.
60 Automatic / Manual
au.ma.
Enable automatic / manual selection. (See paragraph 7.6)
Disabled (Default)
dis.
Enabled
En.
Enabled with memory
En.St.
61 Digital Input
dGt. i .
Digital input functioning (P59 selection must be
Disabled (Default)
dis.
Start / Stop
st.st.
Run N.O. (enables regulation with N.O. contact)
rn.n.o.
Run N.C. (enables regulation with N.C. contact)
rn.n.c.
Lock conversion N.O. (stop conversion and display value with N.O.)
L.c.n.o.
Lock conversion N.C. (stop conversion and display value with N.C.)
L.c.n.c.
Manual Tune (by digital input)
tune
Automatic / Manual Impulse (if enabled on parameter 60)
a.ma.i.
Automatic / Manual Contact (if enabled on parameter 60)
a.ma.c.
62 Gradient
Grad.
Rising gradient for Soft-Start or pre-programmed cycle
0 Disabled (Default)
1-9999 [Digit/hour
63 Maintenance Time
ma.ti.
Maintenance time for pre-programmed cycle
00.00-24.00 hh.mm. Default: 00.00
12
Display of decimal point depends on setting of parameter
13
Display of decimal point depends on setting of parameter
40 - ATR243 - User manual
12
] (degrees.tenths if temperature).
13
] (degrees/hour with display of tenth for temperature sensor)
or ). (See paragraph 7.11)
cont. Pr.cY.
sen. and parameter
sen. and parameter
d.p.
d.p.