Smiths Medical BCI SPECTRO2 30 Simplified Operation Manual

Quick Reference Guide
WW1030
6
For use by or on the order of a licensed physician.
f
Attention, see operation manual for additional instructions for use.
BCI ®

Pulse Oximetry Monitoring

1. Insert the sensor cable connector into the port located on top of the device.
2. Press the On/Off key (
3. Place the sensor on the monitoring site.
,
pulse rate, pulse strength and Pulse amplitude Index (PI) bar will be displayed.
4. SpO
2

Pulse Volume

1. From monitoring mode, use Up/Down arrow keys (
2. Continue to press the Down key to silence the pulse tone completely.

Silencing Alarms

1. Audible alarms can be silenced for two (2) minutes.
2. To silence the alarm tone, briefly press the Alarm Silence key (
3. The Alarm Silence indicator will light solid for the first minute and 45 seconds, then flash the last 15 seconds.
4. To cancel the 2-minute silence, briefly press the Alarm Silence key (
NOte: the Alarm Silence key will not affect visual alarm indicators or pulse tone.

Changing the Alarm Limits

1. To change the alarm limits, press the
2. Press the up or down key (
3. Press the Menu key (
Exit key (
4. To exit, press the

entering Setup Menu

1. Power oximeter on by pressing the
2. When the patient number (Example:
press the Menu key (
3. The Averaging Menu will be the first option.
WW1924-ADD7 REV 0
Simplified Operation Guide
x
) to turn the oximeter on.
Menu key (
n o
) to increase or decrease the setting.
) to advance to the next alarm limit.
) or wait 20 seconds until the patient reading is displayed.
x
On/Off key (
P1) is displayed, press and hold the Exit key (
).
AVG will be displayed. Release the Exit key (
J
b
n o
) to raise or lower pulse beep volume.
B
).
B
).
) until the desired parameter's alarm limit is displayed.
) located on the device's upper right side.
s
2009-07
) and then
).
Page 1 of 4
TM