TP-Link Touch P5 User Manual page 35

2. The Enable DHCP Server
3. Specify the IP Address
router will assign addresses within this specified range to its clients. It is from 192.168.0.100 to 192.168.0.199
by default.
4. Enter a value for the
The Address Lease Time
assigned by the router. After the dynamic IP address expires, the user will be automatically assigned a new
dynamic IP address. The default is
5. The Default Gateway is automatically filled the same as the LAN IP address of the router. Enter Primary DNS
and Secondary DNS if the ISP offers.
6. Tap Save.
To view the client information:
1. Select DHCP Client List.
2. You can view the information of connected client.
To reserve LAN IP addresses for a specified client device:
1. Select Address Reservation
Chapter 2 Configure your Touch P5 as a Router
checkbox is enabled by default.
Pool, the start address and end address must be on the same subnet with LAN IP. The
Address Lease Time.
is the amount of time in which a DHCP client can lease its current dynamic IP address
120 minutes.
and tap Add to add an address reservation entry for your device.
34