GE M60 Instruction Manual page 171

CHAPTER 5: SETTINGS PRODUCT SETUP
Communications Guide for MMS and SCL access. Note that if you update the IEC 61850 settings in the EnerVista software
by writing to them by MMS while the corresponding IEC 61850 panel is open in EnerVista, you need to close then open the
panel in EnerVista for the correct readings to display.
All IEC 61850 protocol configuration settings are accessed through software panels that are selected either in the Online
Window area (see figure) or the Offline Window area in the EnerVista software.
Figure 5-10: IEC 61850 protocol panel in EnerVista software
5
The IEC 61850 window is divided into a navigation pane on the left and a settings panel on the right. You expand and click
an option on the left to display its panel on the right. The following figure shows an example for Server Configuration. The
setting entry panel contains in the SETTING column the names of the settings, and the settings entry boxes are in the
PARAMETER column. Hovering the mouse over a setting name displays a tool-tip showing the 61850 information model
name of the setting or its location in SCL files.
Figure 5-11: Main IEC 61850 panel
Opening the IEC 61850 window while online causes the UR Setup software to retrieve and import an SCL file from the
connected M60. This SCD file contains all the settings in the UR at the time of the file request, both those that are mapped
into the IEC 61850 information model (that is, the "public" sections) and those that are not in the model (that is, the "private"
M60 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL 5-43