FLIR M5104 Instruction Manual page 28

9 Using the System
2. Configure the following settings as needed:
NOTE
The settings listed below are only shown if they are supported on the selected camera. Some camera
models do not support all settings.
• Cable Type: Select the cable type. It is recommended to use Coaxial, as it is the
default for MPX camera. Use UTP with MPX cameras only if you are using cabling
with resistance higher than 10Ω per 100m (330ft) and you are having image quality
issues.
• Time Period: Configure the time periods during which the camera settings will be
enabled.
• Saturation: Adjust the vibrancy of colors in the image.
• Brightness: Adjust the image brightness.
• Contrast: Adjust the image contrast.
• Chroma: Adjust the image chroma.
• Sharpness: Adjust the image sharpness.
• Enhance: Enhance the image.
• NR: Adjust the noise reduction of the image.
NOTE
It is recommended to use the Default settings, as altering the image settings may impact the cam-
era's performance at night.
3. Click OK to save changes.
NOTE
You must save changes to apply settings changes. It is recommended to adjust one setting at a time
so you can see the results of each change. Click Default to reset the camera to default image
settings.
#LX400096; r.45547/45547; en-US
18