Factory Default Settings; Setup Wizard - Gemtek Systems R921212G User Manual

computers. Microsoft Internet Explorer 4.0 or higher or Netscape 4.0 or higher must
be used for the web-based configuration tool.

Factory Default Settings

Dell pre-configures the Router with the following settings:
NOTE: If you lose track of the device settings, you can reset the router by pushing the
reset button to restore these settings back to your router.
Setting
User Name
Password
Device Name
IP Address
Subnet Mask
10 Mbps Ethernet WAN IP
WAN DHCP Client
ESSID (wireless network name)
Channel
Encryption
DHCP Server
NAT Routing
NOTE: Your Wireless Broadband Router came with factory default settings that should
work for the majority of the network usage scenarios. However, there are cases
where your network environment may require a different router configuration.

Setup Wizard

Introduction
Default
admin
admin
my router
192.168.2.1
255.255.255.0
<obtain from ISP via DHCP>
Enabled
wireless
6
No Encryption
Enabled
Enabled