Gemtek Systems CPE7000 Quick Installation Manual

CPE7000 Outdoor Dual Mode - Quick Installation Guide
Introduction
This Quick Installation Guide covers the basic installation of the CPE7000 Outdoor Dual Mode
Overview
The CPE7000 is a Dual Mode subscriber station designed to provide Internet access for a home or small office which
provides the 4G Internet link.
The device includes:

One standard RJ-45 Ethernet port for LAN connections.

One 8 PIN RJ-45 Ethernet port for connection to the ODU. This cable provides a dedicated Power-over-Ethernet (PoE) power
supply to the ODU, and should be connected to an AC power connection (100 to 240 V, 50 to 60 Hz).

One RJ-11 port for VoIP connection to telephone.
The package includes:

The LTE ODU Device

One POE power supply

US power cord

Quick Start Guide

PoleMount (M10~100Bolt, Nuts & Spring Washers)
Before installing the ODU, verify that you have all the items listed in the package checklist. If any of the items are missing or
damaged, please contact your service provider.

Installing the ODU

The ODU should be pole-mounted outdoors and aligned so its antenna faces the nearest base station. When selecting a
suitable location for the unit, consider these guidelines:
•
Place the ODU as high as possible to achieve the best possible link quality.
•
Place the ODU away from power and telephone lines.
•
Avoid placing the ODU too close to any metallic reflective surfaces.
•
Be sure to ground the ODU with an appropriate grounding wire (not included) by attaching it to the grounding screw on the
unit and to a good ground connection.
Check below items on the CPE to help you install the outdoor CPE smoothly:
•
One RJ-11 connector for connecting to the telephone line.
•
One RJ-45 connector for connecting to the PoE adaptor.
•
LED indicator inside and SIM card slot for inserting SIM card.
•
A grounding screw on the rear panel.